When a pipe splits inside a house, stop the supply at the main shutoff and open a low faucet to drain the lines. A plumber then finds the failed section, cuts it out and replaces it with new pipe or fittings. Call the number on this page to be connected with a local plumber in Oldsmar.

Where the water ends up
Gravity decides what gets wet. A break in the attic soaks insulation and ceiling drywall first, and a break in a wall runs down to the baseboard and the slab edge. In slab homes there is no basement to catch it, so water spreads across tile or flooring toward doors. Check every room below and beside the suspected break.
Slab homes and buried lines
Most homes here sit on a slab, so supply lines often run through the attic or under the floor. A line under the slab can fail from corrosion, abrasion on gravel or soil shifts, and water may surface far from the break. Hot floor spots or a running meter are the clue, and a plumber can trace the line.
Stop the water at the source
The main shutoff is your best tool. In many homes it sits in a ground box near the street meter or on an exterior wall. If the valve is stuck or the leak is on the street side, the water utility can shut off service at the meter. Then drain the lines through a low faucet.
Where the money goes
| Part of the job | What drives it |
|---|---|
| Finding the break | Access, and how many walls or ceilings must be checked to locate it |
| Pipe and fittings | Material that matches your existing plumbing |
| Opening and closing walls | Drywall, paint or tile in the affected rooms |
| Permits | Local rules, which apply to larger replacements |
Who to call for what in Oldsmar
In Oldsmar, drinking water and service lines fall under the City of Oldsmar Public Utilities, and Oldsmar Utilities handles the sewer side.
If the leak is at the meter or in the street, call Oldsmar Utilities at 813-749-1226; a plumber handles the pipe on the house side.
If you ever smell gas, leave the house first and call 911 and your gas utility from outside; the emergency number is on your gas bill.
Pinellas County Building Services issues the plumbing permits for Oldsmar addresses.
Nearby, the same kind of help is available in Palm Harbor, Safety Harbor and Dunedin.
Preventing the next burst
A pressure regulator and gauge help keep fittings from being overworked, and a plumber can test the pressure in a few minutes. Replace old washing machine hoses, learn where every shutoff valve is and look into planned repiping if the house still has polybutylene or galvanized pipe, before the next failure.
Burst Pipe Repair questions in Oldsmar
Who handles a burst on the street side of the meter?
How do I dry out my Oldsmar house after a burst?
Will the plumber need a permit to fix a burst pipe?
Can I keep using water in Oldsmar after a burst pipe is repaired?
More plumbing services in Oldsmar
Burst Pipe Repair nearby
Helpful guides
Sources
Last updated: