A sump pump that runs constantly may have a stuck float, a failed check valve or a pit that fills from a high water table. A plumber from near Pinellas Park can find the cause. Call the number on this page to be connected with a local plumber in St. Petersburg.

Sounds that matter
A rattle often means gravel or debris in the impeller. A shrill whine suggests worn bearings. A gurgle after the pump stops can mean the check valve is letting water return. A click with no hum points to a stuck float or a failed switch. Describe the sound when you call.
Pool areas, equipment rooms and commercial sites
Where a sump pump shows up here, it is often at a pool equipment pad, a below-grade utility room or a commercial building with a low floor. These sites need dependable drainage because equipment sits near the water. A plumber checks pump rating, power and the place the water goes.
Much of the housing here dates to the 1960s, so any pits or drainage there may be older and worth inspecting during a pump replacement.
Details worth sharing for a better range
Pit depth and width? It decides pump size. Where does the discharge go? Long runs add pipe. Is there power nearby? A new outlet adds work. Does it run only in storms? That hints at the cause. Mention these on the phone for a closer first range.
Know your providers in St. Petersburg
In St. Petersburg, drinking water and service lines fall under the City of St. Petersburg Water Resources, and St. Pete Water Resources handles the sewer side.
A break on the utility's side of the meter, or water bubbling up in the street, goes to St. Pete Water Resources at 727-893-7261.
For a gas odor in St. Petersburg, get everyone out, then call 911 and Peoples Gas at 877-832-6747 from a safe distance.
Permitted work in St. Petersburg, such as a water heater swap or new gas piping, is filed with the City of St. Petersburg Building & Permitting.
Nearby, the same kind of help is available in Pinellas Park, Seminole and Largo.
How a typical sump pump visit goes
First comes diagnosis: the plumber tests power, the float and the check valve and watches a cycle. Next is the repair, such as a new float or check valve, or installing a new pump. Finally the plumber runs water through the pit, checks the discharge and shows you the result.
A pre-season pump drill
- Pour a few gallons into the pit and watch the float rise.
- Confirm the pump shuts off when the pit empties.
- Check that water leaves through the discharge.
- Test any alarm or battery backup.
Doing it before June makes storm season far less stressful.
Around St. Petersburg
Calls come in from across St. Petersburg, including around Snell Isle, Old Northeast, Historic Roser Park.
Sump Pumps questions in St. Petersburg
Is a sump pump the same as an ejector pump?
What is a check valve and do I need one?
Who do I call about a leak at the meter in St. Petersburg?
Do older homes have drainage trouble more often?
More plumbing services in St. Petersburg
Sump Pumps nearby
Helpful guides
Sources
Last updated: